Created as a solution for my side skirts which had become brittle and were missing clips/attachment points. I scanned, designed, and developed this as a permanent solution to solve this issue, and reinforce it to ensure I could re-install my side skirts for many years to come without trouble.

Kit includes enough parts FOR ONE SIDE to replace the top row smaller brackets, and a full set of the black push clips with foam washers to insert into the car’s rocker. If you need to repair both sides you will need 2x kits. My northeastern car driven relatively hard all year only needed two replaced, so hopefully you have enough and some spares. I found replacing all of these was smart due to them getting worn out and either snapping, or the seal had withered away and could rub through painted surfaces.

INCLUDES:
- 6x PLAGGDESIGNS brackets (shown in red)
- 12x Black Plastic Push clips w/ foam washers (shown in blue)

*Glue not included, use any high strength application, I chose gorilla superglue with a clamp for a few ours. Be sure to sand the surfaces to make sure you flatten any remainders of the OEM bracket, and give better adhesion.